It is prudent to power flush a heating system immediately before fitting a new boiler to an existing system to prevent possible future problems. Many systems are found to contain corrosion and sludge, even if no flow problems have yet shown themselves.

Existing debris is often mobilised by alterations to the system/piping and the increased efficiency of the new boiler, and may then accumulate in the boiler heat exchanger, causing noisy operation, reduced efficiency and, in extreme circumstances, failure of the boiler. The high efficiency and compactness of modern boilers, developed to minimise fuel costs and pollution, means that they are more susceptible to problems caused by debris in the system water.

The clear flow power flushing pump is simply connected in to the central heating system. By using a Kamco professional power flushing pump, heating systems can be purged of sludge, scale and corrosion deposits with minimal fuss and disruption. The power flushing pump is connected into the system via a standard pump connections, across the tails of a radiator or where ever is convenient. The powerful flow, combined with instantaneous flow reverser device will dislodge and mobilise deposits and ‘magnetite‘, which resists tradition system cleaning methods.

Once the corrosion and sludge deposits have been loosened and mobilised, fresh clean water is forced through the heating system, pushing the contaminated water out through a full bore dump valve to waste. During the CLEARFLOW process, radiators are individually flushed, without removing or disconnecting them from the system, by directing the full output of the pump through each radiator separately.

At the end of the flushing process, the system contains fresh clean water and reinstatement of the system to normal operation takes only a few minutes.

System flushing will not remedy design or mechanical faults, which should be rectified, but in many cases it will cure the problems caused by these.